SAAB V4 Forum
SAAB V4 Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
 All Forums
 Classified Ads
 Parts Wanted
 engine mounts

Note: You must be registered in order to post a reply.
To register, click here. Registration is FREE!

Format Mode:
Format:BoldItalicizedUnderlineStrikethrough Align LeftCenteredAlign Right Horizontal Rule Insert HyperlinkInsert EmailInsert Image Insert CodeInsert QuoteInsert List

* Forum Code is ON
Smile [:)]Big Smile [:D]Cool [8D]Blush [:I]
Tongue [:P]Evil [):]Wink [;)]Clown [:o)]
Black Eye [B)]Eight Ball [8]Frown [:(]Shy [8)]
Shocked [:0]Angry [:(!]Dead [xx(]Sleepy [|)]
Kisses [:X]Approve [^]Disapprove [V]Question [?]

Check here to subscribe to this topic.

T O P I C    R E V I E W
green96v4Posted - 09 Sep 2021 : 12:15:43
Need a couple of good engine mounts (part#8806077)

Trying to eliminate some clutch judder (pressure plate is new, clutch is new, release bearing is new, clutch fork is repaired with no ovaling of the release bearing hole, so running out of ideas and thought I'd try engine mounts....)

let me know if anyone has some good condition mounts, can be delivered to my UK address is it's easier

5   L A T E S T    R E P L I E S    (Newest First)
DerekPosted - 11 Sep 2021 : 14:42:51
OK, I'm with you now. Thanks.
mellePosted - 10 Sep 2021 : 13:33:50
Not sure I understand what you mean, my tool is nothing to do with the slave pushrod, it only checks the position of the release bearing in relation to the input shaft (concentricity/ coaxiality) and the arm (parallelism, i.e., if it leans forward or backwards in relation to the shaft the arm hinges on).
DerekPosted - 10 Sep 2021 : 13:16:40
After you have found the best position, how do you adjust the arm to match it? I thought that the slave pushrod was a fixed length.
green96v4Posted - 09 Sep 2021 : 15:08:31
wow - interesting and something I've never measured

that would be engine back out though to measure/fix
mellePosted - 09 Sep 2021 : 12:53:31
I turned the centre of an old clutch plate into a tool to check the position of the release bearing (a piece of welding rod/ stiff wire and a hose clamp will work as well I suppose). I found on my car the release bearing sat a few mm low; after I fixed that with a washer the judder was gone.

Sorry, I don't have any engine mounts...

Snitz Forums 2000
SAAB V4 Forum© 2000-04 Snitz CommunicationsGo To Top Of Page